by AznChipmunk » Sat Jun 17, 2006 9:03 pm
You have to add a command somewhere that sets the 'inputed variable' back to zero, and a fork condition that when that variable is at zero, and a certain switch is on, speed changes back. You need a switch, so you wont get slower and slower. So make a switch turn somewhere next to the 'speeding up' command, and, make another fork condition under the one listed above before you make him slow down.
Kinda hard to explain. xD Be sure to give me credit. Or something...
EDIT: Ya know, if you can't figure it out, it's a lot easier to have him run after psuhing it once, and walk after pushing it again. Toggling, or something like that.
*Whacks head against desk